Re: NT initialization file, or Registry entry?

truckerx (
Wed, 30 Apr 1997 14:11:28 -0400

Steve Hoffmann wrote:
> If this has been answered before, please accept my apology as I have just subscribed to the mail-list.
> I am attempting to run the NT version of CU-SEEME on a NT 4.0 SP2 Intel PC. The initial installation went fine, and CU-SEEME
> worked fine until I changed the camera setting to use a 1/4 scale (80x60) image setting. Quite obviously this was a mistake,
> as CU-SEEME immediately crashed. Subsequent attempts to restart CU-SEEME result in an "information box" stating
> "Unsupported video capture setting".
> Upon clearing this information box, by clicking on "OK", brings up the initial CU-SEEME screens followed immediately by a
> Dr. Watson error message stating:
> "cu-seeme.exe
> Exception: access violation [0xc0000005], Address:0x0041f863"
> I have re-installed both CU-SEEME32 and the Quick-Cam NT drivers, yet this condition persists. Apparently the video setting is
> being stored either in a .ini file somewhere, or in a Registry Entry that is not being cleared by a re-install.
> I would greatly appreciate information on how to clear this unsupported video setting so I may once again use CU-SEEME.
> thanks,
> Steve Hoffmann

You must use 16 greys with NT