FS200 SETUP

Bennett Frankel (drbf@cais.cais.com)
Wed, 1 Feb 1995 15:05:52 -0500


Well after hours of work I can send video as confirmed on the test reflector
and others. This is what I did.
1) Install the FS2oo and make sure that the cap board is working with
Microsoft Video for Windows.
2)run CU-SEEME, make sure on start up you see the hourglass and the
status bar says "initializing capture palette"
!Now the Fun"
3)I installed windows NT 3.1
4)Made a boot disk
5)Made my config.sys as follows
DEVICE=c:\windowsnt\HIMEM.SYS
BUFFERS=20,0
FILES=80
STACKS=9,29
6)Made my autoexec.bat file as follows
@C:\STORE\redirect.exe
SET TEMP=C:\WINDOWS\TEMP
LH/L:O C:\WINDOWSNT\SMARTDRV.EXE
C:\WINDOWS\WIN
7)CU-SEEME RUNS BETTER (NO TIME OUT ERROR) WITH MY SCREEN SAVER ENABLED
YES THAT IS ENABLED.
I hope this helps, please let me know if I can be of further assistance.
Bennett.