Re: No response over a dial-up

Sgt Daniel W. Erskine (
Tue, 30 Jan 1996 08:53:41 -0600 (CST)

On Mon, 29 Jan 1996, Dr. Vijay Aswani, Ph.D. wrote:

> I recently tried to set up a dial up network as follows:
> I ran NetManager TCP/IP Custom on one machine in a 'Listen for Connections' mode. This machine had an IP number and was hooked to a 14.4 modem.
> I connected to it using a TCP/IP dial up networking applications (Win95). The computer dialling in had the IP number
> I checked that the two machines were in a TCP/IP network by 'pinging' the IP numbers.
> did not have a camera attached. I launched CUSeeMe.
> I launched CUSeeMe on the computer through which I had dialled in using another 14.4 modem. This machine had a QuickCam set up so that it could transmit video.
> I had made sure that both the machines had the same settings in the Cuseeme.ini file.
> When I tried to connect to from, I got the message 'No response from'.
> When I tried to connect to from, would open a received video window with the right title but the window would be blank. No image. The screen on would say connected to but meanwhile would simple say 'No response from' (although 192.1.13 had received the signal).
> What's happening? What should I do? Any help will be appreciated.....
> Thanks,
> Vijay
If I remember correctly, Mr. Bill Woodland had found a possible solution to
your problem. You might want to drop him an Email at "" and see
what he says!
Correct me if I'm wrong... You are trying to "network" 2 dial-up hosts and
use CU-SeeMe, directly?

Hope this helps you!
"THERE IS NO SANITY... Just organized CHAOS!!!"


Sgt Daniel W. Erskine ""
PHONE: (618) 256-6891 ""