CU-SeeMe Mac under MachTen

William O Ferry (WOFerry+@CMU.EDU)
Mon, 1 May 1995 03:00:42 -0400 (EDT)


I have a Mac Performa 636 CD 8/1000, System 7.1.2P, on which I run
MachTen 2.1.1 (Unix for the Macintosh). When I try to run
CU-SeeMe.68k0.80b2, I get the error "Error -23015 during `Can't Open
MacTCP`" I can run other MacTCP apps (Maven, Netscape, Eudora,
Anarchie, etc) just fine under MachTen.
Note that MachTen does replace "MacTCP" with it's own "mactcpd"
stack, but it's almost impossible to tell the two apart. CU-SeeMe does
seem to have a problem with it, however
.
Also, if this is the correct place, I'd like to make some
suggestions for upcoming CU-SeeMe versions. I feel that more of the
settings should be preserved by CUSM. For example, every time I start
CUSM, I have to reset my brightness, contrast, volume threshold (for non
Push-To-Talk), and other settings. It would be nice if these settings
were preserved from one run to the next. Plus, a way to automatically
connect to a certain reflector at startup would be nice (is this already
possible in the Mac version?)
Any help would be greatly appreciated. Thanks in advance.
Will Ferry

------------------------------------------
email: WOFerry+@CMU.EDU
finger: WOFerry+@CMU.EDU
talk: finger above address for online status
www: http://www.contrib.andrew.cmu.edu/~wf27/