RE: CU-SeeMe via ATI Mach64

Sgt Daniel W. Erskine (derskine@safb.af.mil)
Tue, 7 Nov 1995 11:32:35 -0600 (CST)


>Dan,
>
>I also have the "ATI Mach64 PCI video card" and
>I have a vidiola/ProD video card. I can't
>get Cu-Seeme to put a picture out. Have you
>heard of any workarounds?
>
>Dan Ward
>warddc@cat.com
>
Greetings:
Before I start, let's go through a few checks first:

1. Does your capture board use ATI Mach64's feature connector?
2. If not, are you using a parallel port, separate card, etc?
3. Do you have the "msvideo.drv" and the "msavi.drv" drivers
loaded through your "Control Panel (Drivers)" section?
4. If these drivers are installed, does your capture card produce or
capture video data properly (aside from using CU-SeeMe)?
5. If not, check with your product vendor for configuration issues.

These ideas are what I'ld use for troubleshooting. As for the video
card, I've been told by an ATI representitive that... well, I'll just
forward you a copy after this message. Our cards don't work well when using
the feature connector. The only other alternatives are to use video capture
products using parallel ports and/or separate expansion cards.
Other than that, I'm still researching for that "ultimate" capture card
that will also display as a television for screen captures.

Good luck in your quest!

[=============================================================================]
"THERE IS NO SANITY... Just organized CHAOS!!!"

Sgt Daniel W. Erskine "erskined@transcom.safb.af.mil"
COMM: (618) 256-6891 "derskine@caesar.safb.af.mil"
AUTOVON: 576-6891 "derskine@apci.net"
[=============================================================================]